Driveshaft Shop Steel Driveshaft Honda S2000 00-06

Driveshaft Shop Steel Driveshaft Honda S2000 00-06

S2000 1-piece Steel Shaft. This driveshaft is a 1-piece steel unit that uses u-joints on either end, instead of the factory cv design that is notorious for failure at higher horsepower. Driveshaft Shop includes aluminum conversion plates on either end to convert the 4-bolt flange to fit in the 6-bolt factory location. Please specify if your vehicle is an AP1 or AP2 when ordering.

Please Note: All aftermarket driveshafts might be slightly larger than factory specs therefore minor clearance might need to be cut or cleared in the driveshaft tunnel. Driveshaft should have a minimum of 1/2" clearance for proper use.